Home › Leaking tap: fix it yourself or call a plumber?
Guide · Newborough plumbing

Leaking tap: fix it yourself or call a plumber?

A dripping tap is one of the most common household annoyances. Some leaks are an easy fix, others are best left to a plumber. Here is how to tell the difference.

Identify your tap

Washer taps

Separate hot and cold taps that turn several times from off to fully on. Inside is a jumper valve with a rubber washer.

Quarter-turn ceramic taps

Separate taps that turn only a quarter or half turn. Inside is a ceramic disc cartridge.

Mixer taps

A single lever controlling both temperature and flow. Inside is a cartridge.

Leaks you might fix yourself

If you are handy and confident, you can replace the washer in a traditional washer tap:

  1. Turn off the water at an isolation valve or the meter.
  2. Open the tap to drain it.
  3. Remove the handle and cover, then unscrew the tap body.
  4. Replace the washer, or the whole jumper valve, with the correct size.
  5. Reassemble and turn the water back on slowly.

Cleaning a blocked aerator on the spout is also a simple job.

When to call a plumber

  • The tap still drips after a new washer. The seat is probably worn and needs refacing or replacing.
  • Mixer taps. Cartridges are brand-specific, and fitting the wrong one or damaging the body is easy.
  • Water leaking from the base or handle. This can involve O-rings or internal seals that need the right parts.
  • You cannot turn the water off. A seized meter tap or no isolation valves is a job for a plumber.
  • Leaks inside the wall. Water stains, bubbling paint or damp behind a shower or bath mean the leak is behind the wall.
  • Corroded or old taps. Parts may snap or strip when you try to dismantle them.
  • Braided hoses under the sink. If they are old, kinked or rusty, replace them before they burst.

The risks of DIY

The biggest risks are damaging the tap body, stripping threads, and being unable to turn the water off again. A small drip can become a flood if a tap is damaged with the water still on, or a meter tap snaps.

What a plumber does

We isolate the water, identify the tap and its parts, replace worn washers, jumper valves, cartridges or O-rings, reface the seat if needed, and test the tap. We also check for isolation valves and can add them so future repairs are easier. If the tap is beyond repair, we can replace it with a new one.

How quickly should you fix a drip?

Sooner is better. Drips waste water, add to bills, stain basins and get worse over time. Hot water drips waste energy too.

Ring 03 8658 7998 if you would rather have it fixed properly the first time.

Handy guides

More guides

Burst pipe: what to do in the first ten minutesA step-by-step guide for Newborough households when a pipe bursts: shutting off water, protecting the house, what to tell your plumber and insurer.Finding your water meter, stopcock and isolation valvesWhere to find the water meter, main stopcock and isolation valves in a typical Newborough home, how to turn them off and what to do if they are stuck.Frozen pipes in a Latrobe Valley winterHow to protect pipes, taps and hot water relief lines from frost in Newborough and the Latrobe Valley, and what to do if a pipe freezes or splits.Heat pump or electric hot water in the Latrobe Valley?Comparing heat pump, electric storage and solar hot water for Newborough and Latrobe Valley homes: running costs, cold winters, space, noise and rebates.Hot water temperature rules in Victoria, explainedA plain-English guide to hot water temperature rules in Victoria: the 60 degree storage rule, the 50 degree bathroom limit, tempering valves and scald safety.No hot water? A quick checklist before you callSimple checks for Newborough households with no hot water: switchboard breakers, off-peak timers, relief valves, tank leaks and when to call a plumber.Plumbing in Newborough's post-war homesWhat to expect from the plumbing in Newborough's original post-war houses: clay sewers, galvanised pipe, old hot water units and what to check when buying or renovating.Stormwater after a storm: what to checkWhat to check around your Newborough home after heavy rain: gutters, downpipes, pits, pooling water and signs your stormwater system is failing.Toilet cistern faults explainedA guide to common toilet cistern faults in Newborough homes: running water, slow filling, weak flushes, leaks and how each is fixed.Tree roots in old clay sewersWhy tree roots get into Newborough's old clay sewer pipes, the warning signs, how roots are cleared and the options for a permanent fix.
Book a plumber

Send us the job details

Send the details and a licensed plumber from Newborough will call you back. Water flooding or a sewer overflowing? Do not wait for a reply, ring 03 8658 7998 now.

03 8658 7998

Every job is quoted on what we actually find. That is why you will not see a price list on this site.







    Plumbing problem in Newborough?

    Ring a local licensed plumber. You hear the price before any work starts.