Home › Leaking Tap Repairs Newborough
Plumber fitting the braided hoses of a new kitchen mixer tap at a stainless sink
Leaking taps · Newborough VIC 3825

Leaking Tap Repairs Newborough

A dripping tap wastes thousands of litres a year and keeps you awake at night. We fix and replace leaking taps and mixers in Newborough kitchens, bathrooms and laundries. Ring 03 8658 7998.

Why taps leak

Taps are opened and closed thousands of times a year, so the parts that seal the water eventually wear out. The fix depends on the type of tap.

Traditional washer taps

Older Newborough homes often still have separate hot and cold taps with a jumper valve and rubber washer inside. Over time the washer hardens and flattens, and the brass seat it closes against gets pitted. Water then sneaks past even when the tap is turned off hard. Replacing the washer alone sometimes helps for a while, but if the seat is worn we reface it so the new washer has a smooth surface to seal against.

Ceramic disc taps

Quarter-turn taps use two ceramic discs that slide over each other. They rarely drip from wear alone, but grit can scratch the discs or the seals around them can fail. The fix is usually a new cartridge to suit the tap.

Mixer taps

Single-lever mixers use a cartridge that controls both flow and temperature. A worn cartridge causes drips from the spout, leaks around the lever, stiff handles or water that will not mix properly. We identify the brand and fit a matching cartridge, or recommend a replacement mixer if parts are no longer made.

Leaks from the base or spout

Water pooling around the base of a tap or seeping from the spout joint usually means worn O-rings. On swivel spouts, the O-rings wear as the spout is swung back and forth.

Leaks under the sink

Flexible braided hoses connect most modern mixers to the water supply. These hoses have a limited life, and when they fail they can burst and flood a kitchen. If yours are more than about ten years old, rusty or kinked, they should be replaced.

What a tap repair involves

  1. We isolate the water to the tap, either at an isolation valve under the sink or at the meter.
  2. We dismantle the tap and identify the worn parts.
  3. We replace washers, jumper valves, cartridges or O-rings, and reface the seat if needed.
  4. We reassemble, test for drips and leaks, and check the flow and operation.

Most tap repairs take less than an hour. We carry a range of common washers, cartridges and seals on the ute.

Repair or replace the tap?

Repair makes sense when the tap is in good condition and parts are available. Replacement makes sense when:

  • the tap body is corroded or cracked
  • parts are no longer available
  • you are tired of the look or it is hard to use, especially for older hands
  • you want a water-efficient model

We supply and install quality tapware, or fit taps you have bought yourself. If you are upgrading from separate taps to a mixer, we check the existing holes and pipework so the new tap fits properly.

Outside taps

Garden taps take a beating from weather and hoses. A leaking garden tap, a tap that has come loose from the wall, or a leak inside the wall behind the tap are all things we fix. We can also add new garden taps where you need them.

How much water does a dripping tap waste?

A tap dripping once per second can waste a surprising amount of water over a year. That shows up on your water bill, and a leaking hot tap also wastes the energy used to heat the water.

Common tap noises

  • Squealing or chattering when the tap is turned on. Often a loose jumper valve or worn washer vibrating in the water flow.
  • Banging when the tap is turned off quickly. Known as water hammer. It can be caused by high pressure, loose pipes or quick-closing taps and appliances. Pressure limiting valves and water hammer arrestors can fix it.
  • Hissing. A partly blocked aerator or a worn seat.

Cleaning tap aerators

The aerator on the end of the spout mixes air into the water to make the flow smooth. Over time, grit and scale build up and reduce flow. You can unscrew most aerators by hand, rinse them and screw them back on.

Taps for older hands

Lever taps and mixers are easier to use than traditional twist handles for people with arthritis or weaker grip. Swapping old taps for levers in the kitchen and bathroom is a simple change that makes daily life easier.

Tap repairs in rentals

A dripping or broken tap in a rental is a repair the landlord is responsible for. We work with property managers and tenants to get it fixed quickly.

Where we fix taps

Newborough, Moe, Yallourn North, Hernes Oak, Moe South, Morwell, Traralgon, Trafalgar and Tanjil South.

Included

What you get with leaking tap repairs

On the ute
Drain camera with locator, jetter, electric eel, acoustic leak detector, thermal camera, pressure test gear
Licensing
Victorian licences for water supply, sanitary, drainage and roofing
Quoting
Cause explained and price agreed before work, written quotes for larger jobs
Parts
WaterMark-certified fittings and products that meet Australian Standards
Certificates
Compliance certificates for regulated plumbing work, photos for your records or insurer
Leaving
Old parts removed, the work area cleaned and everything tested with you
Questions

Leaking Tap Repairs in Newborough: questions

Is it worth fixing a dripping tap?

Yes. A dripping tap wastes water, adds to your bill and can stain sinks. A hot tap drip also wastes the energy used to heat the water. Most repairs are quick.

Can I fix a leaking tap myself?

Simple washer changes are possible if you know how to isolate the water. Mixer cartridges and worn seats are harder, and getting it wrong can damage the tap. Ring 03 8658 7998 if you are not sure.

How long do mixer tap cartridges last?

Typically several years, but hard water, grit and heavy use shorten their life. A stiff lever or a drip from the spout means it is time for a new one.

Do you install taps I have bought myself?

Yes, as long as they are WaterMark certified and suit your sink or basin.

Why does my tap still drip after a new washer?

The brass seat the washer closes against is probably worn or pitted. Refacing or replacing the seat gives the new washer a smooth surface to seal on.

Can you replace old separate taps with a mixer?

Usually, yes. We check the hole positions and the pipework behind the wall or under the sink so the new mixer fits and seals properly.

Do you fix leaking garden taps?

Yes. We replace washers and spindles, fix taps that have come loose from the wall and repair leaks in the pipe behind the tap. We can also add extra garden taps where hoses have to stretch too far.

Book a plumber

Send us the job details

Send the details and a licensed plumber from Newborough will call you back. Water flooding or a sewer overflowing? Do not wait for a reply, ring 03 8658 7998 now.

03 8658 7998

Every job is quoted on what we actually find. That is why you will not see a price list on this site.







    Why Newborough rings us

    Straight answers and tidy work

    We know valley houses

    Post-war SEC brick and weatherboard homes, 1970s units, new estates on the edge of Newborough and lake-side blocks: we know what is usually hiding in the walls and under the lawn.

    The price comes first

    You get the cause and the cost before work starts. If the plan changes once we open something up, we stop and talk to you first.

    Proper diagnostic gear

    Drain cameras, jetters, acoustic leak detectors and thermal cameras mean we find the fault instead of guessing and digging.

    Plumbing licences

    Water, sanitary, drainage and roofing work done by licensed tradespeople, with the paperwork lodged where the law requires it.

    Service area

    Towns we cover from Newborough

    We work out of Newborough and cover the valley from Moe and Yallourn North across to Morwell and Traralgon, plus the hill blocks around Tanjil South and Moe South. Not on the list? Ring 03 8658 7998 and ask.

    Plumbing problem in Newborough?

    Ring a local licensed plumber. You hear the price before any work starts.