Toilet cistern faults explained
Most toilet problems start inside the cistern. Knowing what each part does makes it easier to work out what has gone wrong.
The parts inside a cistern
- Inlet valve: lets water in after a flush and shuts off when the cistern is full.
- Float: rises with the water and tells the inlet valve when to stop.
- Outlet valve: at the bottom of the cistern, opens to flush and closes with a rubber seal.
- Flush buttons: connected to the outlet valve by a linkage.
- Overflow: a pipe that sends excess water into the bowl if the cistern overfills.
Fault: water keeps running into the bowl
Likely cause: the inlet valve is not shutting off and water is going down the overflow, or the outlet seal is leaking.
Check: take the lid off. If the water level is up at the top of the overflow pipe, the inlet valve is the problem. If the level is below the overflow but you can hear trickling, the outlet seal is leaking. The food colouring test helps here: add a few drops to the cistern and wait twenty minutes without flushing. Colour in the bowl means the outlet seal is leaking.
Fix: adjust or replace the inlet valve, or replace the outlet valve seal or the whole outlet valve.
Fault: the cistern fills slowly
Likely cause: a partly closed isolation tap, a blocked inlet valve filter or a faulty valve.
Fix: open the isolation tap fully, clean the filter or replace the inlet valve.
Fault: weak flush
Likely cause: water level set too low, worn outlet valve, a partial blockage in the pan or drain, or mineral build-up under the rim.
Fix: adjust the water level, replace the outlet valve, clear the blockage or descale the rim.
Fault: the button sticks or does nothing
Likely cause: a broken or misaligned button linkage.
Fix: realign or replace the button mechanism.
Fault: water on the floor
Likely cause: a leaking connection to the water supply, a failed seal between the cistern and pan, condensation on cold days, or a failed pan connector at the floor.
Fix: tighten or replace the connection, replace the seals or replace the pan connector. Condensation is not a leak, but it can be reduced with better bathroom ventilation.
Fault: the toilet rocks
Likely cause: loose floor fixings or a failed seal at the pan connector.
Fix: reseat the pan, replace the seal and secure it properly.
DIY or plumber?
Adjusting the float or water level is often simple. Replacing valves and seals needs the right parts for your brand and model. If you are not sure, or water is on the floor, ring 03 8658 7998. Most cistern repairs are finished in one visit because we carry common parts for the main brands.
More guides
Send us the job details
Send the details and a licensed plumber from Newborough will call you back. Water flooding or a sewer overflowing? Do not wait for a reply, ring 03 8658 7998 now.
Every job is quoted on what we actually find. That is why you will not see a price list on this site.
Plumbing problem in Newborough?
Ring a local licensed plumber. You hear the price before any work starts.